The steam mop becomes very hot and could burn you if you accidentally mop your feet.ĭo not use the steam mop without water. Mold and mildew may grow on the pad which could ruin the cleaning head.Īvoid using the mop with bare feet. This may damage your floor.Īvoid packing the steam mop away with a dirty cleaning pad. The steam mop will build up heat and steam quickly. The mop heats up quickly so you may burn yourself while preparing it for mopping.ĭo not let the steam mop go idle or stay in one place for too long. What To Avoid When Using a Shark Steam Mopĭo not plug the Shark Steam Mop in before you’re ready to mop. This will ensure that the floors are thoroughly dried.Ĭhoose the dust setting on your mop for a gentle clean and do not use any chemicals that might break the sealed barrier protecting your floor or cause damage to the floor itself. Make sure that you use a highly absorbent microfiber pad. You can also use a shark steam mop on hardwood floors if the floors are sealed. Can You Use a Shark Steam Mop on Hardwood Floors? Now, move the mop with the grain across the floor and clean in sections rather than trying to clean the entire floor at once. However, you can use a shark steam mop on laminate floors.įirst set the shark steam mop on the driest setting possible by setting it to the highest temperature and the least amount of water possible. Normally you would not want to clean laminate floors with a steam mop because the water may damage the floors. Can You Use a Shark Steam Mop on Laminate Floors? Store the mop by hanging it up on a large hook. Remove the mophead once it’s cool enough to remove safely. Now empty the water tank by removing the cap and holding the tank over a sink. You’ll need to release the quick-release fasteners and pull on the lavender loop. Leave the mop to cool for 2-3 minutes before handling it.Ĭarefully remove the cleaning pad. Unplug the mop and let it stand in an upright position. When you are done, press the on/standby button until it begins to flash blue. This will not clean the carpet but it will groom it. You will move the mop back and forth across the carpet. To refresh or groom your carpet, place the mop head on top of the carpet glider. If the water tank empties, again you will need to unplug your mop before refilling it. Then you can change the cleaning pad or mophead. If you need to change the cleaning pad, unplug the mop and wait 2 or 3 minutes for the mop to cool. When one side of the cleaning pad gets dirty, quickly flip the mophead to the other side to continue mopping your floor. If you are cleaning laminate or hardwood floors, move the mop in the same direction as the grain. The awesome thing about the Shark Steam Mop is that it works on any type of floor. Clean Your FloorsĬlean the floors with forwards and backwards motion. Press it three times for the scrub setting. Unwrap the cord and plug it into a 120-volt outlet. Pull out the cord of your steam mop by pulling the quick-release cord holder. It’s meant for deep cleaning heavily trafficked areas and will also sanitize the floor. It will cut through the dirt and grime allowing it to be removed. This setting is used for tough cleaning, stuck-on messes, and stains. Intended Surface: Tile, Stone, Linoleum Carpet with a carpet glider May be used carefully on hardwood floors but is not intended for continuous use.Activate: Press the on/standby button three times.It will loosen small messes from the floor and is best used for moderately and heavily trafficked floors. This setting is used for everyday cleaning.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |